Introduction to the Structure of Dalian Stamping Mold_San'ao Metal_ Dalian stamping mold,Dalian stamping parts

Introduction to the Structure of Dalian Stamping Mold

Release Time：

2023-04-14

The structure of Dalian stamping die, the structure of the die, the mold structure is similar, according to different product characteristics and needs to design the corresponding mold, different mold structure, its function is also different, the products produced are also different, in general, there are simple, there are complex. But no matter how complex the structure, its basic structure is unchanged, nothing more than several templates, blocks and standard parts.

Introduction to the Structure of Dalian Stamping Mold

The structure of Dalian stamping die, the structure of the die, the mold structure is similar, according to different product characteristics and needs to design the corresponding mold, different mold structure, its function is also different, the products produced are also different, in general, there are simple, there are complex. But no matter how complex the structure, its basic structure is unchanged, nothing more than several templates, blocks and standard parts.

The mold is generally assembled from several templates and parts (we call them blocks, or inserts) and standard parts.

Dalian stamping die

The general stamping die structure, the specific template from top to bottom (including code number) is:

The templates for the upper mold are:

Upper pallet, upper foot, upper mold base (UPU), upper pad plate (UBU), upper splint plate (PHU) stop plate (PPS), stripping plate (PSU);

The templates for the lower mold are:

Lower Template (DIE), Lower Pad (LBD), Lower Mold Base (LPD), Lower Foot, Lower Pallet;

Other less commonly used templates:

Upper cover plate (CVU), knockout plate, upper template, lower stripping plate, lower stop plate, lower splint, male mold, mother mold, etc.;

Some mold parts are:

The entry of the upper mold, the block: the clamp plate into the block, the dematerialing plate into the block, the punch, etc.;

The entry of the lower mold, the block: the lower mold into the block, the knife edge of the lower mold, etc.;

Standard parts: spring, hexagonal screw, stop screw, wire spring, contour sleeve, guide column, guide sleeve, contour set gasket, dual-purpose pin, top material pin, etc.;

Non-standard parts: external positioning, internal positioning, pitch positioning, outer limit column, inner limit column, etc.;

The stamping die number, which is generally written like this (for example):

Engineering molds: 90-KNMF0125RAH, 90-KNMF0125RAA, 90-KNMF0125RBB

Continuous mode: 90-KNMF0125SAA, 90-KNMF0125SBB

The latter RAH, R represents the engineering mold, and H represents a total of eight sets (from A-H, respectively, RAH, RBH...). RHH), A stands for the first set; RAA or RBB stands for riveting die, such as rivet studs, rivet shrapnel, etc.;

Sorry，当前栏目暂无内容!

Sorry，The current column has no content!